Learn
Learn automation.
One path, 7 steps. Start with the warehouse, go inside the robots, follow a tote to the station — and finish by fixing the errors you'll meet on site.
01
Software
02
Network
03
Robot
04
Controller
05
Driver
06
Motor
07
Sensor
08
Feedback
SOFTWARE → NETWORK → ROBOT → CONTROLLER → DRIVER → MOTOR → SENSOR → FEEDBACK → SOFTWARE
Learning path
Start anywhere. Go in order if you're new.
STEP 01
Warehouse fundamentals
Follow a tote from inbound to outbound.
INBOUND → STORAGE → PICKING → OUTBOUND
StartSTEP 02
VTM Academy
Inside the Vertical Tote Mover: X-ray, signal flow and drivers in 3D.
EXTERIOR → X-RAY → SIGNAL → DRIVERS
StartSTEP 03
HTM Academy
Inside the Horizontal Tote Mover: drive, tote transfer and manual control.
EXTERIOR → SENSORS → TASK → MANUAL
StartSTEP 04
Conveyor & PPS flow
Follow a tote to the Pick-Put Station and see every message.
BOT → CONVEYOR → STATION → RELAY
StartSTEP 05
Networking & Moxa
Wi-Fi, roaming, RSSI and the robot's WLAN client.
BASICS → ROAMING → RSSI → WLAN CLIENT
StartSTEP 06
Software & APIs
The software stack, VDA 5050 and orchestration.
STACK → ONE COMMAND → VDA 5050
StartSTEP 07
Troubleshooting
Fix the HTM and VTM errors seen on site, then practise layer by layer.
ROBOT ERRORS → LAB → METHOD → SOPS
Start
Your automation stack
0% explored
- Warehouse fundamentals0%
- VTM Academy0%
- HTM Academy0%
- Conveyor & PPS flow0%
- Networking & Moxa0%
- Software & APIs0%
- Troubleshooting0%
Saved in this browser only.