Skip to content

SOP · Safety · VTM · HTM

E-stop & safety state

Why a robot with a valid command still won't move when the safety chain is open.

Purpose

Understand safety state as a layer independent of software commands.

Prerequisites

  • Site safety training

Safety considerations

  • Follow your site's lockout / isolation and robot-zone entry rules before approaching equipment.
  • Only trained, authorized personnel perform service actions. This page is concept training.
  • Never bypass or override safety devices.

Normal behavior

Safety chain closed; motion permitted only in allowed conditions.

Conceptual operation

  • E-stop / safety devices → safety circuit → drive enable.

Inspection points

  • E-stop state
  • Protective field status

Diagnostics

  • Safety state indicator

Common symptoms

  • Commands accepted but no motion

Recovery decision tree

  1. 1. Is a safety condition active?

    YES → Resolve the cause per site procedure.

    NO → Check controller/drive state.

Authorized procedure

INTERNAL / AUTHORIZED ONLY

Safety reset procedures — available only in the model-specific, authorized SOP for your site. Not published on this website.

Verification

  • Safety chain closed and motion normal

Escalation

Site safety lead.