Skip to content

SOP · Networking · Moxa

Weak signal (RSSI)

Why signal strength changes along a route and what low RSSI does to robot availability.

Purpose

Recognise and evidence weak wireless coverage.

Prerequisites

  • RSSI readings with location and time

Safety considerations

  • Follow your site's lockout / isolation and robot-zone entry rules before approaching equipment.
  • Only trained, authorized personnel perform service actions. This page is concept training.

Normal behavior

RSSI stays above the site's target throughout the route; roaming happens before the signal becomes unusable.

Conceptual operation

  • RSSI falls with distance and obstacles (racking, totes, metal).
  • Interference and channel congestion raise latency and packet loss even when RSSI looks acceptable.

Inspection points

  • Antennas and cables
  • New obstructions near the route

Diagnostics

  • RSSI trend by location
  • Packet loss / latency at the same location
  • Roaming events

Common symptoms

  • Robot offline in the same zone repeatedly
  • Slow state updates

Recovery decision tree

  1. 1. Is low RSSI tied to a location?

    YES → Coverage issue — escalate with a map.

    NO → Check the device/antenna on that robot.

Authorized procedure

INTERNAL / AUTHORIZED ONLY

Site thresholds and AP configuration — available only in the model-specific, authorized SOP for your site. Not published on this website.

Verification

  • RSSI and packet loss acceptable over repeated runs

Escalation

Network team with RSSI map.

References