Skip to content

SOP · VTM · HTM · Drivers · Motors

Motor / servo drivers

How drivers turn controller commands into motor power — and how requested vs actual becomes a fault.

Purpose

Understand the closed control loop and fault categories.

Prerequisites

  • Safe service state

Safety considerations

  • Follow your site's lockout / isolation and robot-zone entry rules before approaching equipment.
  • Only trained, authorized personnel perform service actions. This page is concept training.
  • Drives can hold stored energy — follow isolation procedures.

Normal behavior

Following error small; no drive faults.

Conceptual operation

  • Controller sends motion instruction → driver regulates current → motor moves → encoder feeds back → controller compares requested vs actual.

Inspection points

  • Drive status indicators

Diagnostics

  • Fault category: communication, encoder feedback, motor, overcurrent/overload, position mismatch, safety/interlock

Common symptoms

  • Axis disabled
  • Repeated faults under load

Recovery decision tree

  1. 1. Is it a feedback fault?

    YES → Check encoder signal/cabling (authorized).

    NO → Check load, mechanics and drive status.

Authorized procedure

INTERNAL / AUTHORIZED ONLY

Drive parameters and tuning values — available only in the model-specific, authorized SOP for your site. Not published on this website.

Verification

  • Moves complete without faults

Escalation

Vendor support.